01-13-2012 06:16 AM
I have two different networks that need to work on the same RMX 4000, I have plugged network one into the one MPM x card and have plugged the second network into the second MPM x card.
I have created the Default Network service and I can make calls to and from network 1.
Q1. Where do I configure the IP address, subnet mask and gateway for network 2 plugged into the second MPM x card?
Q2. I have tried adding new routes under Router but can’t get calls working to the second network or from it, do I need a License?
Q3. Or do I need to create a second Network Service for the second network as per the admin guide ver 7.2.1 page 501, if so do I need a license and what is that license called?
Q4. As per admin guide one needs to load the following system flag “MULTIPLE_SERVICES = YES” , this does not load it says something about a license, what license please?
01-13-2012 07:22 AM
There are licenses with can extend the functionality of your RMX. One of these is indeed support of Multiple Network services which you need to support your different network requirements. I would suggest contacting a reseller or the person/group who sold you the RMX to see how about purchasing this additional license. See my screenshot from my System Information page below: