cancel
Showing results for 
Search instead for 
Did you mean: 

Group System support for Visca

Occasional Visitor

Group System support for Visca

Hi all

 

Integrators reference manual shows a serial cable for group

2457-63542-001

but states that the pinout does not support Visca. 

 

" The 8-pin mini-DIN RS232 connection is wired per Polycom RS-232 and does
not follow VISCA pinout convention. Do NOT try to use a cable meant to support
VISCA in this application as it will not work correctly
"

 

If I have the correct cable, does group 500 support Visca cameras ? 

 

Thanks

Message 1 of 3
2 REPLIES
Polycom Employee & Moderator

Re: Group System support for Visca

The list of supported non-Polycom cameras is listed in the release notes for the software version you are using.  See the interoperability section.

 

You would use the proper HDCI breakout adapter for the camera you are using, which would provide a serial interface for your VISCA connection.  Refer to the Group Series Integrator's Reference Guide for additional information on the HDCI adapter cables that are available.

Message 2 of 3
Highlighted
Occasional Visitor

Re: Group System support for Visca

Thanks

 

I understand that in the case you mentioned camera control will use the serial connection through the breakout cable. 

How about the serial port on the enpoint GS310/500? Is it possible to control a VISCA camera, connected to the HDMI content port, through this serial port ?

 

In this case I believe we can´t use the group remote control, but instead we would need an automation solution to send telnet commands to the group system, correct ? 

 

 

Message 3 of 3