Sleep Mode starts while in presentation

[kdavidsontaylor]

I've just purchased the HDX 8000.  I've had one recurring problem that I can't seem to find a solution in the User's Guide.  The system goes into sleep mode after a few minutes if I'm not holding the remote.   I can't hold the remote the whole time that I'm in a presentation.  How can I change this? 

Karin

[GaryMiyakawa · Accepted solution]

Karin,

Using the remote, go to System -> (1) Admin Setting -> (3) Monitors -> (1) Monitors -> page 4 of 4 "Screen Saver Wait TIme"....

Change it to what you need...

Cheers,

Gary M

[kdavidsontaylor]

I found that solution only minutes ago - just before I checked back here.  I couldn't find it in the User's guide for 3.0.5, but found it in 3.0.4.  I hadn't gone far enough on the Monitor tab.

Thanks so much. Karin

[GaryMiyakawa]

Very good!  BTW, it is talked about in the HDX Administrators guide (3.0.5)....   (for future reference)

Gary M