06-19-2017 06:17 AM
UC Software Version: 5.5.2
Phone Model: VVX 601
Headset: Plantronics Voyager Bluetooth Headset
This issue appears to be occurring to two out of several users. A headset will be paired and connected to the VVX 601, however, when a user initally attempts to activate their headset using the hard button on the unit, the headset will be briefly connected and then switch over to speaker phone.
So if a user wants to make a call/use their headset, the VVX will show their headset as paired (Bluetooth/headset icon), they will press the physical headset button which will light up blue, then within a 3-4 second window even when dialing a number, the VVX 601 will switch over to speaker phone. Once switched over to speaker phone, the physical speaker phone button will glow green until the user presses the speaker phone button to turn off the speaker phone or they press the physical headset button a second time to re-engage the headset.
So far, this has been a consistent issue for two users on brand new phones. I've tried rebooting the unit and there do not appear to be any more recent updates available nor do the Polyom release notes include any note of this as an issue - either known or resolved. I also do not see any related configuration setting which I could adjust to prevent this behavior.
Any further ideas or suggestions?
06-19-2017 06:28 AM
Hello Polycom Quest,
welcome back to the Polycom Community.
Did you ever solve your issue => here <= ?
For you new question please contact your Polycom reseller so they can open a case for you.
If this is some sort of an Internet discounter please post either your phone's MAC address or your Polycom devices serial so I can look up who would be able to support you. This may not be who you purchased the Polycom device from.
Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.
Polycom Global Services
06-19-2017 06:59 AM
For the previous issue, I ended up contacting my Polycom reseller who then sent me a replacement unit.
As for this issue, I was wondering if it might be a bug that Polycom knew of or experienced with the most recent UC softwre release - annoying more than show stopping when the user would like the button to function on the first attempt to engage the headset.
I'll go ahead and re-connect with my reseller.