Plantronics + Polycom. Now together as Poly Logo

Bridging between Polycom DMA 7000 and Cisco TMS (I think)

Highlighted
Advisor

Bridging between Polycom DMA 7000 and Cisco TMS (I think)

Hi,

 

I'm looking for some advice on how to configure our system. We have recently installed Polycom hardware (DMA 7000, RPRM and VBP's), however another region bought a Cisco setup. All our endpoints are registered to our DMA while theres are registered to there Cisco TMS (basically Cisco's version of the DMA) - there is no intergration, no global address book.

 

I'm told there is a way of 'bridging' the two together so they share one address book, is this possible? If so how is it done?

 

I'm reading about a 'supercluster', however from what I've read that is only for Polycom DMA's and there is a requirement that they all run the same OS etc as they share the config....

 

Is anyone able to adise on how to configure this?

 

Many thanks

Message 1 of 2
1 REPLY 1
Highlighted
Honored Contributor

Re: Bridging between Polycom DMA 7000 and Cisco TMS (I think)

Hi there...

maybe you could take a look here.

Kind regards,
Uwe
Message 2 of 2