Plantronics + Polycom. Now together as Poly Logo

Limited bandwidth from HDX to VBP 4350

SOLVED
Highlighted
Occasional Advisor

Limited bandwidth from HDX to VBP 4350

Hello,

 

as you can see in the following link, I currently managed to route our HDX, which calls (internet addresses), to our VBP 4350.

Other Topic

 

Our HDX use a bandwidth up to 4096 Kbps for internal calls. But as soon as we try to do a call to external partners our VBP 4350 says:

 Duration: 0:00:00
Call-ID: 4F19F077-B800-001F-0400-397EDF2CF58B
Call-Status: Incoming Q.931 TCP connection established
Termination Cause: At maximum bandwidth usage

 

I could limit the bandwidth with our cma 4000 in the "Dial Plans and sites" section to 1472 Kbps, but this limit  apply for all internal and external connections. Is there a possibility to limit only the Connection between our HDX/Endpoints and the VBP4350?

 

Best regards

Adam

 

 

Message 1 of 4
1 ACCEPTED SOLUTION

Accepted Solutions
Polycom Employee

Re: Limited bandwidth from HDX to VBP 4350

You would have to create a site for these HDXs and a site link to the Internet with these restrictions.

 

S.

View solution in original post

Message 2 of 4
3 REPLIES 3
Polycom Employee

Re: Limited bandwidth from HDX to VBP 4350

You would have to create a site for these HDXs and a site link to the Internet with these restrictions.

 

S.

View solution in original post

Message 2 of 4
Highlighted
Occasional Advisor

Re: Limited bandwidth from HDX to VBP 4350

Thank you Simons for your advice, it works perfectly. An alternative solution is to limit the Bandwidth between proxy and Internet/external.

 

Best regards

Adam

Message 3 of 4
Highlighted
Occasional Visitor

Re: Limited bandwidth from HDX to VBP 4350

I have a similar issue, but it's related to inbound dialing. 

 

Customer has a Polycom CMA 6.2.1 ER8 and a VBP 11.2.13.

Our service allows us to join their endpoints into our meeting software.  All of their endpoints are registered with the VBP so every time we call we are calling from one of our servers into the VBP.  We connect two endpoints but as soon as we dial the third the call gets rejected saying the is insufficient bandwidth.  My guess is that since we are making three separate calls from the same IP Address it is lumping us together with some sort of bandwidth restriction.  


How do I take the limit off of the inbound connections?  Do I need to add our IP Address(s) in a whitelist? 

Message 4 of 4