cancel
Showing results for 
Search instead for 
Did you mean: 

C12 Soundstructure and SX80 Relays?

Highlighted
Occasional Visitor

C12 Soundstructure and SX80 Relays?

Hi All

 

Hope someone can help / advise?

 

We are currently on a job setting up a meeting room that has a divide wall to make it 2 rooms. We have 1 Polycom Ceiling mic in one room and 2 in the other. This will be open and closed via a touch panel to send 232 commands to "logic ports" on the rear of the soundstructure if i understand correctly.

 

My question is mainly re connection.

 

SO when in open mode for the room all mics i want to be active and when in closed mode i only want the 2 mics to be active.

 

On the Soundstructure programme i have grouped the microphones and selected the presets so "power on" will have the one mic room muted and another preset "Open" unmutes it. 

 

How do i go about making this happen? Am i correct in asuming i need to use the Logic ports on the rear of the soundstructure?

 

This is all then going out to a Cisco SX80 codec and back in also.

 

Thanks very much everyone

 

 

 

 

Message 1 of 1