We have a CMA 4000 (v. 5.4), RMX 1000 and VBP 5300 E ( 11.2.6) and RSS. There was a need to change the internal IP addresses. After the changes were made to all equipment, we can make connections internally after the change but we cannot make outgoing or in-coming calls. I can web into the VBP, RMX , CMA and RSS. We can see the RMX and the RSS in the CMA but do not see the VBP. We only have the option to add a VBP -ST not E. On the CMA we have made the correct change of the VBP inside address in the sites/ routing/ bandwidth portion. Is there another setting I need to change on the CMA and/or VBP to get these two to communicate to eat other? Any advise would be greatly appreciated.
... We can see the RMX and the RSS in the CMA but do not see the VBP. We only have the option to add a VBP -ST not E...
This is normal. Routing through VBP is configured in CMA Site's properties.
If your VBP acts in LAN side GK mode (I guess it is so) check if the LAN/Subscriber-side GK address is pointed to CMA.
Hope this could help