Plantronics + Polycom. Now together as Poly Logo

VBP ST IN DMZ

Sujoy
Occasional Advisor

VBP ST IN DMZ

We are facing an issue with VBP ST 5300 installation in a site.

While it works very well when we have the Public ip directly connected to the box.

It does not work when we put the VBP in the DMZ behind client firewall and we are given natted IP ie CMA DESKTOP cannot register from outside in this condition.

 

Can anyone help how to make the setup work placed in the DMZ.

Message 1 of 2
1 REPLY 1
Ahmed-Shabana
Frequent Advisor

Re: VBP ST IN DMZ

it is clearly mentioned in the admin guide that NAT is not supported on the VBP.

 

below is from the admin guide

 

Note: You cannot NAT a VBP. It is the Layer 3 NAT that causes the H.323-NAT issue the VBP resolves. If you NAT
a VBP interface, you will have the same issue you had before you implemented a VBP, just relevant to fewer IP
addresses.

Message 2 of 2