cancel
Showing results for 
Search instead for 
Did you mean: 

Anyway to change the Director II wide shot?

Occasional Contributor

Anyway to change the Director II wide shot?

Hi all - We've purchased a number of Director II 's that we've paired with GS 700s. The tracking is working great, but I am hoping someone knows of a way to change the default wideshot it uses when it's not displaying a single speaker. 

 

It currently likes to default to shooting straight ahead, which captures way too much of the ceiling. It's at just under 7' above floor.

I've tried setting the preferred wideshot at preset 0, and using it as either camera 1 or 2, but so far, it still defaults to shooting straight ahead.

 

All firmware is up to date on endpoint and Director II.

 

Thanks for the help!

Message 1 of 5
4 REPLIES
Highlighted
Polycom Employee & Moderator

Re: Anyway to change the Director II wide shot?

Did you try this, from the RP Group Series Admin Guide:

 

 

 

 

 

Adjust the Room View

 

 

You can adjust the room view on the EagleEye Director to get the best perspective for your video calls.

Procedure

Do one of the following:

From the local interface, go to >

Settings > Administration > Camera Tracking > Calibration, and then select Begin Calibration.

From the system web interface, go to

Admin Settings > Audio/Video > Video Inputs, and then select the Input used by the EagleEye Director.

 

 

Do one of the following:

In the local interface, select

Skip to move to the Adjust Room View screen.

In the system web interface, select

Adjust Room View.

 

 

Use the arrow buttons and zoom controls on the remote control or system web interface to show the room view you want far site participants to see.

 

Select

Finish to save the settings and return to the Camera Settings screen.

Message 2 of 5
Occasional Contributor

Re: Anyway to change the Director II wide shot?

Those directions work for the Director I we have connected to an HDX 9004 but NOT the Director II. No settings for "set room view" in the web interface or local OSD to do that order of operations on either a GS500 or GS700 paired with the Director II.

I would say this feature is missing and we need a firmware update to do.

I did notice there has been FW releases since I posted for the Director II and GS line, but release notes did not indicate that room view would be added. I will update tomorrow to confirm that.

Message 3 of 5
Occasional Contributor

Re: Anyway to change the Director II wide shot?

Got around to updating the firmware to the most recent:

 

GS700: Release - 6.1.2.1-380105

Director II: 1.1.0.23-543

 

I went through your listed steps and there is still no way to select change room view from either the local or web interface. Can this feature request get submitted from here or is there a better way?

Message 4 of 5
Polycom Employee

Re: Anyway to change the Director II wide shot?

Rob,  you need to adjust the analytics camera (small center camera).  Do this by using the remote control, Turn Tracking Off, Aim the remote toward the EEDII,  press the Home button on the remote for 5 seconds, press the up or down arrow to suit the room view you want, then press either right or left arrow button. Turn tracking back on.

This adjusts the room camera view for desired height. 

 

Other camera controls are located in the GS WebUI under Diagnostics, Audio and Video tests, Camera tracking.

 

Ken... 

Ken
Polycom
Sr. Product Support Technician
Message 5 of 5