Hi Polycom,
I would like to display far end on 2 monitors when connecting to the RMX bridge. So basically each monitor will display the bridge (far end) layout. I tried to enable both monitors to only display Far End Video on the HDX but only 1 monitor is displaying far end but not both.
Here is my settings in my HDX
Admin Settings > Monitors
Monitor 1 : Display Far end (ticked), Display Near Video (Unticked), Display Content (Unticked)
Monitor 2 : Display Far end (ticked), Display Near Video (Unticked), Display Content (Ticked)
Thanks
This works only from SW version 3.1.3. Set 2nd monitor to "Monitor 1 Image"