we have a problem with the systems HDX7000/8000/900x ver. 220.127.116.11-19040 and 3.0.4-20259.
Scopia400 RADVISION MCU ver. 18.104.22.168.10.
Service-Video MCU - Portocol H.261-H.263-H.264 384Kbps - and resolution up to CIF.
When a system HDX with ver. 22.214.171.124-19040 or 3.0.4-20259 333 comes into meetings, endpoint does not send the video.
while if the same system hdx comes with ver. 126.96.36.199-17007 or 188.8.131.52-13047 or 184.108.40.206-5205 video works.(NO FW)
Another test, same Service on MCU removing the protocol H264. The video works fine.
Or if in the same Service select bandwith 768Kbp and resolution up to 720P with H.264 the video works fine.
The problem seems to be linked to the component h264 and CIF. With older versions was fully functional.
I found some other posts about having a basic mode turned on, but in recent firmware the basica mode is missing. What we did find, was that diagnostic mode was turned on, and this disabled h.264.
Once we disabled this we had everything working properly. But only H261 and not H264. In this case for all call to be made H.264 are disable.
I need to make call H.264 and CIF for Standard Definition. Of course everything is OK if I make a P2P calls "forced" this protocol and resolution.
Can you help me?
welcome to the Polycom Community.
Thank you for bringing this to our attention but the correct procedure should be that you contact your Polycom Reseller and/or Polycom Support directly as troubleshooting an issue of this kind is not within the scope of the community.
Feel free to update this post with a resolution or some feedback once you worked through the correct escalation channels.
Polycom Global Services