My Polycom G700 couldnt get out of the reset mode, its light keeps flashing and never get off even I followed the instruction of factory reset the device. This codec is out of the warranty so it doesnt get the support from the engineer insteed of send it back for repair.
Hello @Vu Le ,
Welcome to the Poly Community.
It would be a good starting point for us volunteers within this community to provide some basic details what was done to the codec to get into this state?
Usually, we ask for this:
Both the communities Must Read First and the FAQ reference the basic minimum information a new or follow up post should contain.
This ensures the questions having to be asked are limited and any new or follow up post contains the right amount of details to ensure any voluntary participant within the community does not spend additional time chasing basic information.
As a reminder the basic information asked for:
Whilst providing some of these details may not directly impact any possible answer the community can provide, it does enable Poly to have an overview of the current software used. In addition, providing all details at the same time allows us to check logs or look up potential support partners if an issue needs to come into support. It also enables us to verify the entitlement for using features.
Within this official Poly hosted and moderated Community we cannot support any post's about repairing Poly equipment as this may place users in danger.
Posting a serial will enable us to look up the history of a device and point out potential partners who can help you RMA the unit.
Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.