Plantronics + Polycom. Now together as Poly Logo

New Group Series 700 Codec Black Image

Highlighted
Occasional Visitor

New Group Series 700 Codec Black Image

I went throught the setup wizard, I selected 1920x1080.  When the codec boots it displays the Polycom startup screen and goes to a black image.  On the front of the codec LED it reads 1920x1080 VGA?"   It's not on the IP network yet I need to get the MAC address off of it for my network engineer.  Any thoughts on why it's not displaying a image?  Id there a way to change the resolution with the handheld remote?                            

Message 1 of 4
3 REPLIES 3
Highlighted
Respected Contributor

Re: New Group Series 700 Codec Black Image

The MAC can be extracted from the Serial Number.   

Example:

Serial Number: 8213050FD69BCV

MAC:   00:E0:DB:0F:D6:9B

 

As for the Black Video, it sounds like the wrong resolution...   Were you plugged in with VGA or HDMI ?

 

Good luck,

 

Gary M

Wanna' Test your H.323 System? (71.14.2.157 or 71.14.2.158)
cb157.miyakawa.us and cb158.miyakawa.us
www.miyakawa.us
www.codecsidekick.com
Message 2 of 4
Highlighted
Occasional Visitor

Re: New Group Series 700 Codec Black Image

The first time I turned on the codec I was connect to VGA.  It went throught the wizard, it provided me an option to select a resolution I selected 1920x1080.  I think this is was messed it up.  Now I am plugged into the HDMI, I see the Polycom splash screen at boot and whenit''s done I only see a black image.  1920x1080 / VGA is on the led on the front of the codec.  maybe I should perform a factory reset and start over.  I thought there might be a way to change the resolution type i.e. VGA to HDMI via the handheld remote or should it auto detect?

Message 3 of 4
Highlighted
Polycom Employee & Moderator

Re: New Group Series 700 Codec Black Image

If you have not selected the input you have the source on you will not get it.  I was confused on where you have the VGA plugged into.  If it is not the camera 1 input it will not send it.  You can, in the configuration menus, select a different input as the main camera, and it has to be defined as People.  You can not select as the main camera a content source.

 

The monitor output will scale inputs to the right resolution. 

 

 

Message 4 of 4