Security Code Issue with Pano and Mirror Cast from Windows Endpoint

SOLVED
Highlighted
Occasional Visitor

Security Code Issue with Pano and Mirror Cast from Windows Endpoint

Good morning, we are currently experiencing an issue with out Windows Endpoints Mirror Casting to the Pano device and was wondering if anyone else has experienced a similar issue and has a solution. For any of our windows laptops that try to cast for the first time they are asked for the security code to connect which is fine however any subsequent connections then dont ask for the security code. We have rebooted both the pano and the laptops and cleared the credential Cache on the windows laptop but it still happens. This is not an issue on Macs, iPhones or when using the pano app. Any ideas?

 

Thanks.

Message 1 of 3
2 REPLIES
Polycom Employee

Re: Security Code Issue with Pano and Mirror Cast from Windows Endpoint

With Miracast this is the expected behavior. The following statement can be found in the Pano release notes: Systems running the Windows operating system only require a security code during the first attempt to connect. To force personal device to prompt for a security code after the initial attempt, a user can remove the Pano device from the list of connected devices (also referred to as “forgetting” a device).
Message 2 of 3
Occasional Visitor

Re: Security Code Issue with Pano and Mirror Cast from Windows Endpoint

Thank you.

Message 3 of 3