Plantronics + Polycom. Now together as Poly Logo

VSX 7000 Camera view only on startup

Occasional Visitor

VSX 7000 Camera view only on startup

When I turn on the VSX 7000, all I see on the monitor is the camera view. None of the buttons on the remote take me back to the main screen where I can configure or type in IP numbers to make the needed connections. I have installed new batteries in the remote and the remote does move the camera, ie  focus, right, left, up,down, etc., and I can see the light on the front of the unit flash when operating the remote. It is probably something simple but it escapes me at the moment. Is there a factory reset available when you can't get into the system menu because all you see is the camera view? I also don't know what the IP address of the VSX7000 is so a factory reset would work fine.

Message 1 of 3
2 REPLIES 2
Trusted Contributor

Re: VSX 7000 Camera view only on startup

Just a guess but is it possible that you have your Main monitor plugged into Monitor 2?

Pete

Message 2 of 3
Trusted Contributor

Re: VSX 7000 Camera view only on startup

Kevin.  If you do factory reset & have access to DHCP Pol, you'll find the VSX at MAC address 00:E0:DB where the last 6 digits of the MAC are the last 8 digits of the S# minus the last 2 (eg 820912000102AK the MAC will be 00:E0:DB:00:01:02). You can then manipulate Monitor settings from there.  Default username admin, default password S# (in UPPERCASE).

Factory restore is power the unit up holding down the "0" button.  Pete

Message 3 of 3