Plantronics + Polycom. Now together as Poly Logo

What is the standard configuration to allow an incoming call on a HDX7000?

sajovic
Occasional Advisor

What is the standard configuration to allow an incoming call on a HDX7000?

Hi to everyone,

 

my question is very simple, please take 2mn to give me a solution:

 

I have installed a HDX7000 on a private network. My codec has a private ip adress, it is connected to internet through an internet router with a public ip adress and Natting it to the codec.

 

Every outgoing call works very well........ but as soon as an incoming call comes, the connexion is established BUT NO VIDEO, NO AUDIO !!!!

 

Please tell me what is the standard configuration for port opening on the router, and the standard configuration to put on the codec menu.

 

Thanks in advance,

 

Lionel.

Message 1 of 5
4 REPLIES 4
SteffenBaierUK
Polycom Employee & Community Manager

Re: What is the standard configuration to allow an incoming call on a HDX7000?

Hello Lionel,

welcome to the Polycom Community.

The HDX Admin guide that can be found => here <= shows on Page B-1 all port that are being used.

 

In addition the community forum should hold several posts where this has been discussed in the past.

Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.

Best Regards

Steffen Baier

Polycom Global Services

----------------
The title Poly Employee & Community Manager is a community setting and does not reflect my role. I am just a simple volunteer in the community like everybody else. All posts and words are my own & do not represent the views of Employer.

----------------

Notice: This community forum is not an official Poly support resource, thus responses from Poly employees, partners, and customers alike are best-effort in attempts to share learned knowledge. If you need immediate and/or official assistance please open a service ticket through your proper support channels.
Please also ensure you always check the VoIP , Video Endpoint , Skype for Business , PSTN or RPM FAQ's
Message 2 of 5
sajovic
Occasional Advisor

Re: What is the standard configuration to allow an incoming call on a HDX7000?

Hello,

 

sorry but I got this guide since the very beginning, I tried every configuration listed on this guide, I opened every TCP and UDP port required, but based on my experience I'm sure we forgot something very small very stupid but I don't see what!!!

 

If you get some screen hardcopies HDX side and Router side (whatever the router model)..... it will be wellcomed!!!

 

Lionel

Message 3 of 5
Zain
Advisor

Re: What is the standard configuration to allow an incoming call on a HDX7000?

Dear

Your mail says , you has the NAT configure in your Router and you have a Private IP address .

 

So please Go to NETWORK settings and make sure you did not enabled the NAT again on your HDX. If you have NAT on both the device it may give this error . So do the NAT on your router and disable it on HDX.

Message 4 of 5
sajovic
Occasional Advisor

Re: What is the standard configuration to allow an incoming call on a HDX7000?

Dear Zain,

 

You're right!!!! that was one of the possible solutions..... I disabled it on the HDX and....it works!!!! must be written on the administrator guide.

 

Thanks again,

 

Lionel.

Message 5 of 5