-
×InformationWindows update impacting certain printer icons and names. Microsoft is working on a solution.
Click here to learn moreInformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center.
-
×InformationWindows update impacting certain printer icons and names. Microsoft is working on a solution.
Click here to learn moreInformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center.
- HP Community
- Poly Phones
- Desk and IP Conference Phones
- Re: Call Park with Multiple Registrations
Create an account on the HP Community to personalize your profile and ask a question
07-03-2014 12:33 PM
We have recently been installing hosted phones using the Polycom VVX 500 sets on a Genband C15 switch.
I researched and successfully configured call park and retrieve keys on my test phone. It has a single line registration on it.
I went to deploy several phones at a customer site, I used the same config files as I used on my test set, however the Call park fails to complete. I get an error message "call cannot be completed as dialed"
The difference being that the newly installed phones have 6 registrations each.
When testing, I would make a call in or out, and press the Park softkey. On my test phone it uses the same line to initiate the park; I'm assuming it does some kind of hook flash as it only has one registration on it.
However on the other phones when I press the park key it attempts to access the next availalble line. For instance: Call comes in on XXX-XXX-4983, press the park key and it accesses XXX-XXX-4984 I then get the call cannot be completed as dialed message.
I removed all registrations from a phone at the customer site, except one and tested and the park functions works correctly.
Thanks in advance for any help.
I did try searching this first, but didn't have any luck.
Solved! Go to Solution.
Accepted Solutions
07-10-2014 03:10 PM
I added the following string to my config file and it has corrected the problem:
call.stickyAutoLineSeize="1"
Found here
07-04-2014 12:02 AM
Hello dbergland,
welcome back to the Polycom Community.
I would suggest you install a supported version of software on the phone before testing any further.
There is UCS 4.0.6, UCS 4.1.7 or UCS 5.0.2
Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.
Best Regards
Steffen Baier
Polycom Global Services
Notice: I am an HP Poly employee but all replies within the community are done as a volunteer outside of my day role. This community forum is not an official HP Poly support resource, thus responses from HP Poly employees, partners, and customers alike are best-effort in attempts to share learned knowledge.
If you need immediate and/or official assistance for former Poly\Plantronics\Polycom please open a service ticket through your support channels
For HP products please check HP Support.
Please also ensure you always check the General VoIP , Video Endpoint , UC Platform (Microsoft) , PSTN
07-09-2014 07:18 AM
Updated to 5.0.2.2756. Retested with same results.
Test 1 (1 line registered)
1. Placed call to primary number on phone
2. Pressed the Park button
3. Park code is dialed, stutter tone is returned.
4. Pressed retrieve button and dialed park station
5. Call is returned
Test 2 (2 Lines registered)
1. Placed call to primary number on phone (same as above)
2. Press park button
3. Line 2 is siezed and park park code dialed
4. Call cannot be completed as dialed error returned.
Didn't find what you were looking for? Ask the community