Plantronics + Polycom. Now together as Poly Logo

IP 6000 conference in a high noise factory Problems....

Occasional Visitor

IP 6000 conference in a high noise factory Problems....

I'm trying a IP 6000 conference phone in the office of a very noisy factory (Lumber mill). When the remote person speaks, I hear a word or 2 then nothing, they can hear me (with a lot of background noise of course).

 

I assume this is due to the noise cancelling being overwhelmed.  Is there anything I can do to get this environment to work?

Noise cancel setting, config,  we tried to cover the microphones,   or ????    OR have I misunderstood the problem?

 

I'd appreciate any suggestions OR alternate setups   (i.e. headsets with noise cancelling mics,   partition the conference room with noise cancelling material,   go elsewhere for the conference (Not a good solution) or ???

 

Thanks for the help!

Message 1 of 3
2 REPLIES 2
Valued Contributor

Re: IP 6000 conference in a high noise factory Problems....

Hi wrh099,

You might try moving the phone to a quieter environment to see if the issue persists. If it does not, you are right, and the background noise is overwhelming the noise cancellation features on the phone.

 

-James

Message 2 of 3
Advisor

Re: IP 6000 conference in a high noise factory Problems....

There are some mic gain settings that are documented that you might have success adjusting. The official stance from polycom is not to ever mess with them on pain of death, but reducing the handsfree analog rx gain might get you what you want - possibly in combination with increasing the digital rx gain. I have to admit I have had to tweak in these settings a bit for persistent people who think that a speakerphone isn't working properly unless it's louder than a car stereo -- you may know them as the same folks who hold their cell phones to their heads on speakerphone.

Message 3 of 3