Plantronics + Polycom. Now together as Poly Logo

Provisioning via web-portal

Versature
Occasional Visitor

Provisioning via web-portal

Hey everyone,

 

Typically we do not use the web-ui to provision the Polycom phones.  

 

However is there a section in the web-ui where I can set overrides?  Essentially I'm trying to do this: call.missedCallTracking.1.enabled="0"

Message 1 of 4
3 REPLIES 3
SteffenBaierUK
Polycom Employee & Community Manager

Re: Provisioning via web-portal

Hello Versature,

 

welcome to the Polycom Community.

 

The amount of changes that you can make via the Web Interface varies depending on the => Software <= Version you are running on the unknown type of Polycom Phone.

 

I have not personally checked this parameter and usually only basic changes are possible. Since UCS 4.0.0 you can import a configuration.

 

The Community offers plenty of examples.

 

Best Regards

 

Steffen Baier

 

Polycom Global Services

----------------
The title Polycom Employee & Community Manager is a community setting and does not reflect my role. I am just a simple volunteer in the community like everybody else. All posts and words are my own & do not represent the views of Employer.

----------------

Notice: This community forum is not an official Poly support resource, thus responses from Poly employees, partners, and customers alike are best-effort in attempts to share learned knowledge. If you need immediate and/or official assistance please open a service ticket through your proper support channels.
Please also ensure you always check the VoIP , Video Endpoint , Skype for Business , PSTN or RPM FAQ's
Message 2 of 4
Versature
Occasional Visitor

Re: Provisioning via web-portal

Hello,

 

The particular phone / firmware in question is:

 

PolycomSoundPointIP-SPIP_550-UA/3.3.4.0085

Message 3 of 4
SteffenBaierUK
Polycom Employee & Community Manager

Re: Provisioning via web-portal

Hello,

 

I have not got a phone near me running the UCS 3.3.4 but the new UCS 4.0.x has the possibility to import configurations and that would enable you, if your Phone can run the UCS 4.0.x, to load any Configuration Parameters without having to setup a provisioning server.

 

Saying this, in order to upgrade to UCS 4.0.x you will need to setup a server anyway and can then just provide this parameter to the phones in question.

 

Best Regards

 

Steffen Baier

----------------
The title Polycom Employee & Community Manager is a community setting and does not reflect my role. I am just a simple volunteer in the community like everybody else. All posts and words are my own & do not represent the views of Employer.

----------------

Notice: This community forum is not an official Poly support resource, thus responses from Poly employees, partners, and customers alike are best-effort in attempts to share learned knowledge. If you need immediate and/or official assistance please open a service ticket through your proper support channels.
Please also ensure you always check the VoIP , Video Endpoint , Skype for Business , PSTN or RPM FAQ's
Message 4 of 4