Plantronics + Polycom. Now together as Poly Logo

Upgrade IP7000 from 3.2.3 to 4.0.3F

Highlighted
Occasional Contributor

Upgrade IP7000 from 3.2.3 to 4.0.3F

Hi,

 

we have a unified folder for all the polycom devices.

in particular, IP7000 is running 3.2.3 firmware at the moment.

there is a project to upgrade couple IP7000s to 4.0 above to support the integradtion of HDX7000

 

I found that it requires updater 3111-40000-001.bootrom.ld to point the unit to grab the new firmware (no need to upgrade from 4.01 to 4.0.3 for e.g)

however, we don't want to upgrade all IP7000 to the latest firmware.

 

is there a way to tell the IP7000 which bootrom.ld to load, just like modifng the MAC.cfg to tell the phone which sip.ld to load in a SPECIFIC sub-folder??

 

 

Message 1 of 2
1 REPLY 1
Highlighted
Polycom Employee & Community Manager

Re: Upgrade IP7000 from 3.2.3 to 4.0.3F

Hi AmcomIPTel,

 

to my knowledge you can only specify the sip.ld in the <mac>.cfg file.

 

You can on the other hand specify a new file within the config_file="" sections.

 

Lets say you call this redirect.cfg

 

As you are running SIP 3.2.x you also need a sip.cfg and phone1.cfg so it should look like this:

 

config_file="redirect.cfg,sip.cfg,phone1.cfg" 

 Within the redirect.cfg you would then utilize the device.set option and specify a new user on your FTP that points towards the 4.x.x Software. You can also include the username and password.

 

I am nowhere near my own pc so you would need to check the admin guide for the parameters.

 

The phone would on a boot load that new config, change his provisioning server details to the new user and then download the new updater/upgrader and afterwards sip.ld and run the new UCS software.

 

Best Regards

 

Steffen Baier

----------------

Notice: This community forum is not an official Poly support resource, thus responses from Poly employees, partners, and customers alike are best-effort in attempts to share learned knowledge. If you need immediate and/or official assistance please open a service ticket through your proper support channels.
Please also ensure you always check the VoIP , Video Endpoint , Skype for Business , PSTN or RPM FAQ's
Message 2 of 2