Thanks for the reply.
I understand the REFER and the INVITE part but can't quite get why it is sending a REFER to callpark@ourdomain
If you watch this
I can get the button but when I press the button it doesn't dial out to *68 instead it just goes to Dialpad screen and display a CallPark Softkey up the top. I believe there must be some config for the device to know that it should dial *68 when the CallPark key is pressed.
I was wondering if you managed to solve the issue you were facing in your original post?
I am also facing the issue where the park softkey does not seem to insert the required *68 to park the call.
Looking at my efk.cfg config file, the action seem specified correctly.
welcome to the Polycom Community.
It is always useful to include the currently used software version as issues experienced may already be addressed in a newer release.
This also allows yourself and others to check against current software release notes.
The above is also stated in the "Read First: Welcome to the Polycom VoIP Forum"
Therefore the Polycom VoIP FAQ contains this post here:
Question: How can I find out my SIP UC Software Version or the BootROM Version of my Phone?
Resolution: Please check here
Stating the above I had already advised the original post to please raise a ticket with your Polycom reseller to bring this to the attention of Polycom support.
The same would be applicable to you if you have found an issue that you believe needs fixing in a future release.
Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.
Polycom Global Services